4/22/2021 0 Comments Creation Pcut Ct630
I have also tried to get help from other forums, but I get no response, reading through this thread I see many interesting ideas that may help me.It was origonally just a USB plug on the side, I could not connect.It was mother board version 8 (the mother board is in the base of the cutter).
![]() From what I have gathered so far I have been told that is should be a 9 pin,Dsub, but still not sure if its male or female, I have a connector that has a 9 pin male Dsub plug to experiment with, so anyway it is a 9 wire grey ribbon cable with a 10 pin black header plug at the motherboard end, I believe one pin is unused.,,, So I also dont know if the cable between the PC and Cutter is modem or null modem and have been experimenting with two cable ends and a joining block inbetween them, trying all the different pin out wiring that I can, the day it starts cutting I will probably sheet myself with fright. So anyway it still does not work, I am using sign blazer on windows 7. I have not replaced the motherboard on mine in the 4 or so years I have had mine and have had no issues. Creation Pcut Ct630 Driver Downloaded ForMake sure you have the correct driver downloaded for the machine.only times I wasnt able to cut there was an updated driver available. Creation Pcut Ct630 Mac OSX So NotHowever I am using Signcut Pro and running from Mac OSX so not sure if that makes a difference. I think you are brave trying to hand wire a new plug in there. Good luck with it and maybe someone will come along who has done similar. The P-Cuts are a decent cutter but still a stepper motor machine and not terribly expensive to replace outright.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |